Numerical modeling of geothermal reservoir in unsaturated environment (Case study: Geothermal field northwest of Sabalan)

Document Type : Original Article

Author

Faculty of engineering, University of Mohaghegh Ardabili, Ardabil, Iran

10.22059/ses.2023.355432.1024

Abstract

In this research, firstly, a conceptual model designed of ten deep exploratoration wells has been developed, and based on this, a three-dimensional numerical model of the North-West Sablan geothermal system has been presented. For this purpose, the EOS3 module (water-air equation) of the Tough2 simulator code was used to simulate the model. The numerical model of the reservoir is expressed by a rectangular prism with a length of 11.5 km, a width of 8 km (92 km2) and a depth of 5.11 km, and it was expanded with 21 horizontal layers with a thickness range of 100 to 1000 meters from the maximum altitude of 4110 to -1000 masl. The number of 22 rock-types, whose distribution is based on the distribution of rock units and geological structures in 10 deep exploratory wells, was assigned to the model. The permeability of the rock types varies from 1*10E-17 to 9*10E-13 square meters. Modeling was done for the natural state of the reservoir and the validation results showed a good match between the data measured in the well and modeled for temperature and pressure. In the best fit, the simulation provided a zone of high temperature upward flow in the southeastern part of the range (sites D and E). This flow is transferred through permeable, faulted and fractured zones and is finally discharged through surface features (hot water springs) in the northwestern part of the area.

Keywords

References

[1]. G. Gunnarsson, and E.S.P Aradottir, “The deep roots of geothermal systems in volcanic areas: boundary conditions and heat sources in reservoir modeling,” J. Transp. Porous Media, vol. 108, pp. 43–59, 2015, https://doi.org/10.1007/s11242-014-0328-1.
 
[2]. H. Puppala, S. K. Jha, A. P. Singh, R. M. Elavarasan, and P. E. Campana, “Identification and analysis of barriers for harnessing geothermal energy in India. Renewable Energy”, vol. 186, pp. 327-340, 2022, https://doi.org/10.1016/j.renene.2022.01.002.
[3]. K. Pruess, “TOUGH2- a general- purpose numerical simulation for multiphase fluid and heat flow”, Lawrence Berkeley National Laboratory Report LBL-29400. Lawrence Berkeley Laboratory, Berkeley, Earth Sciences Division, California, 1991, https://escholarship.org/uc/item/0wx8q119.
[4]. L. Hu, P.H. Winterfeld, P. Fakcharoenphol, and Y.Sh. Wu, “A novel fully-coupled flow and geomechanics model in enhanced geothermal reservoirs”, J. Pet. Sci. Eng., vol. 107, pp. 1–11, 2013, https://doi.org/10.1016/j.petrol.2013.04.005.
[5]. S.C.P. Pearson, S.A. Alcaraz, and J. Barber, “Numerical simulations to assess thermal potential at Tauranga low-temperature geothermal system”, New Zealand. Hydrogeol. J., vol. 22, pp. 163–174, 2014, doi:10.1007/s10040-013-1076-y
[6]. L. Pan, and C.M. Oldenburg, “T2Well—an integrated wellbore–reservoir simulator”, Comput. Geosci., vol. 65, pp. 46–55, 2014, https://doi.org/10.1016/j.cageo.2013.06.005
[7]. G. Lu, X. Wang, F. Li, F. Xu, Y. Wang, Sh. Qi, and D. Yuen, “Deep geothermal processes acting on faults and solid tides in coastal Xinzhou geothermal field, Guangdong”, China. Phys. Earth Planet. Inter., vol. 264, pp.76–88, 2017, https://doi.org/10.1016/j.pepi.2016.12.004.
[8]. Ch. Guo, K. Zhang, L. Pan, Z. Cai, C. Li, and Y. Li, “Numerical investigation of a joint approach to thermal energy storage and compressed air energy storage in aquifers”, Appl. Energy, vol. 203, pp. 948–958, 2017, https://doi.org/10.1016/j.apenergy.2017.06.030.
[9]. E.K. Bjarkason, J.P. O’Sullivan, A. Yeh, and M.J. O’Sullivan, “Inverse modeling of the natural state of geothermal reservoirs using adjoint and direct methods” Geothermics, vol. 78, pp. 85–100, 2019, https://doi.org/10.1016/j.geothermics.2018.10.001.
[10]. S. Kwon, and Ch. Lee, “Thermal-Hydraulic-Mechanical coupling analysis using FLAC3D-TOUGH2 for an in situ heater test at Horonobe underground research laboratory”, Geosystem Eng., vol. 22, pp. 289-298, 2019, DOI: 10.1080/12269328.2019.1638315 1–10.
[11]. Y. Noorollahi, H. Yousefi, R. Itoi, and S. Ehara, “Geothermal energy resources and development in Iran”, Renew. Sustain. Energy Rev, vol. 13, pp. 1127–1132, 2009, https://doi.org/10.1016/j.rser.2008.05.004.
[12]. S. Porkhial, F. Abdollahzadeh Bina, B. Radmehr., and P. Johari Sefid, “Interpretation of the Injection and Heat Up tests at Sabalan geothermal field, Iran”, Proceedings World Geothermal Congress 2015, Melbourne, pp. 19-25, 2015.
[13]. A. Kosari Torbehbar, and SM. Sattari, “Geochemistry and Isotope Study of Discharged Geothermal Fluids, NW Sabalan Geothermal Field, NW Iran”, Proceedings World Geothermal Congress 2015, Melbourne, pp. 19-25, 2015.
[14]. M. Seyedrahimi-Niaraq, F. Doulati Ardejani, Y. Noorollahi, and S. Porkhial, “Development of an updated geothermal reservoir conceptual model for NW Sabalan geothermal field, Iran”, Geothermal Energy, vol. 22, 2017, doi: 10.1186/s40517-017-0073-0.
[15]. M. Seyedrahimi-Niaraq, and T. Nouri, “Investigating the Economic Effects and the Roadmap of Developing Geothermal Systems to Generate Electricity”, Journal of Renewable Energy and Environment vol. 9, pp. 52-64, 2022, https://doi.org/10.30501/jree.2022.317375.1290.
[16]. SKM (Sinclair Knight Merz), “Geochemical Evaluation of Well NWS-1. Sinclair Knight Merz, Report for SUNA (Renewable Energy Organization of Iran)”, pp. 19, 2005, In Persian.
[17]. Gh. Najafi, and B. Ghobadian, “Geothermal resources in Iran: the sustainable future”, Renewable Sustainable Energy Rev., vol. 15, pp. 3946–3951, 2011, https://doi.org/10.1016/j.rser.2011.07.032.
[18]. S. Porkhial, F. Abdollahzadeh Bina, B. Radmehr, and P. Johari Sefid, “Interpretation of the injection and heat Up tests at Sabalan geothermal field, Iran”, In: Proceedings World Geothermal Congress 2015, Melbourne, pp. 19–25, 2015.
[19]. A. Kosari Torbehbar, and S.M. Sattari, “Geochemistry and isotope study of discharged geothermal fluids, NW Sabalan geothermal Field, NW Iran”, In: Proceedings World Geothermal Congress 2015, Melbourne, pp. 19–25, 2015.
[20]. M. Fotouhi, “Geothermal development in Sabalan, Iran” In: Proceedings World Geothermal Congress 1995. Florence, Italy, pp. 191–196, 1995.
[21]. Y. Noorollahi, and R. Itoi, “Production capacity estimation by reservoir numerical simulation of northwest (NW) Sabalan geothermal field, Iran”, Energy, vol. 36, pp. 4552–4569, 2011, https://doi.org/10.1016/j.energy.2011.03.046.
[22]. E. Kaya, S.J. Zarrouk, and M.J. O’Sullivan, “Reinjection in geothermal fields: a review of worldwide experience”, Renew. Sustain. Energy Rev, vol. 15, pp. 47–68, 2011, https://doi.org/10.1016/j.rser.2010.07.032.
[23]. K. Nicholson, “Geothermal Fluids: Chemistry and Exploration Techniques”, Springer Science & Business Media, p. 263, 2012.
[24]. A.R. Diaz, E. Kaya, and S.J. Zarrouk, “Reinjection in geothermal fields: A worldwide review update”, Renew. Sustain. Energy Rev., vol. 53, pp. 105–162, 2016, https://doi.org/10.1016/j.rser.2015.07.151.
[25]. S. Strelbitskaya, and B. Radmehr, “Geochemical characteristics of Reservoir fluid from NW-Sabalan geothermal Field, Iran”, Proceeding World Geothermal Congress 2010, Bali, Andonesia, pp. 25–29, 2010.
[26]. M. Seyedrahimi-Niaraq, F. Doulati Ardejani, Y. Noorollahi, S. Porkhial, R. Itoi, and S. Jalili Nasrabadi, “A three-dimentional numerical model to simulate Iranian NW Sabalan geothermal system”, Geothermics, vol. 77, pp. 42–61, 2019, https://doi.org/10.1016/j.geothermics.2018.08.009.
[27]. I. Bogie, AJ. Cartwright, Kh. Khosrawi, B. Talebi, and F. Sahabi, “The Meshkin Shahr geothermal prospect, Iran”, Proceedings World Geothermal Congress 2000, Japan, pp. 997- 1002, 2000.
[28]. R. Saber, A. Caglayan, and I. S. I. K. Veysel,
“Landscape response to deformation in the Sabalan area, NW Iran: Inferred from quantitative morphological and structural analysis”, Earth and Environmental Science Transactions of the Royal Society of Edinburgh, pp. 1-26, 2022, doi:10.1017/S1755691022000135.
[29]. A. Amini, “Geological report of Meshginshahr area”, Ministry of Mines and Metals, Geological Survey of Iran, Tehran, 1988, In Persian.
[30]. KML (Kingston Morrison), “Sabalan geothermal project, Stage 1—Surface exploration, final exploration report”, Kingston Morrison Limited Co., report 2505-RPT-GE-003 for the Renewable Energy Organization of Iran, Tehran, p. 83, 1999.
[31]. EDC (Energy Development Corporation), “2009MT survey of NW Sabalan geothermal project, NW Iran”, Report submitted to SUNA, p. 13, 2010.
[32]. J. Bundschuh, and M. Suarez Arriaga, “Introduction to the Numerical Modeling of Groundwater and Geothermal Systems: Fundamentals of Mass, Energy and Solute Transport in Poroelastic Rocks”, vol. 2, pp. 522. 2010, https://doi.org/10.1201/b10499.
[33]. K. Pruess, C. Oldenburg, G. Moridis, “TOUGH2 user’s guide, version 2.0.”, Report LBNL 43134. Berkeley, CA, USA: Lawrence Berkeley National Laboratory, pp. 197, http://esd.lbl.gov/TOUGH2/LBNL_43134.pdf; 1999.
[34]. W. Beckman, S. Klein, “Engineering equation solver professional versions user manual, F-Chart software”, p. 312, 2007.
[35]. E. Y. Turali, and S. Simsek, “A three-dimensional numerical model of Yerköy (Yozgat) hydrogeothermal system, Central Anatolia, Türkiye”, Journal of African Earth Sciences, vol. 198, 2023, https://doi.org/10.1016/j.jafrearsci.2022.104815.
Journal of sustainable Energy Systems
Volume 1, Issue 4
October 2023
Pages 311-327

Files

Share

How to cite

Statistics